Launch element at preset coordinates or within the XYZ cube.
The area of ​​appearance of the 3D object is configured in the Settings Panel of the selected 3D object in the Appearance Area tab.

Launch element on pre-marked filter screen points. If there are no marked points, the launch will be performed in the configured appearance area.
The selection of filter points for launching a 3D object is carried out in the Settings Panel of the selected 3D object in the Filter Points tab.
The appearance area of ​​the 3D object is configured in the Settings Panel of the selected 3D object in the Area tab.

Launch by a randomly specified 3D object launch setting.

If there are no specified launch points, the launch will be performed in the configured appearance area.
The appearance area of ​​the 3D object is configured in the Settings Panel of the selected 3D object in the Area tab.
The selection of filter points for launching the 3D object is performed in the Settings Panel of the selected 3D object in the Filter points tab.

To delete running 3D objects, use the control and display element of the number of running 3D objects of the current template.
When you click on the button, all running 3D objects of the current template are deleted.

It is mandatory to enable all activated triggers. After that, the triggers start counting down time and processing the 3D object behavior conditions.
If the mode is not enabled, the active triggers are in pause mode.